UT探伤通用规程[1]

超声波探伤通用规程UT General Specification Material: EN-GJS-400-18U-LT REFERRENCE: EN 12680-3 检验规程内容：Content 1.0 适用范围/scope 2.0 参考规范/reference 3.0 检验人员/ NDT-Personnel4.0 超声波检测/ Ultrasonic testing5.0 检验报告/Examination report1.0 适用 范围 / scope本规范是铸件的检验规程和验收标准。本规范覆盖检验区域。1/14This specification is the inspection procedures and acceptance criteria of casting. Inspection areas are covered by this specification.2.0 参考规范/referenceGB9445-99：中国机械工程无损检测学会无损检测人员资格及鉴定/non-destructive testing institution of the Chinese mechanical engineering society qualification and certification of NDT personnelEN473 ： NDT 无损探伤试验人员的资格和资格证--总则/ qualification and certification of NDT personnel—general principles.SNT-TC-1A：无损探伤人员资质/ qualification and certification of NDT personnelEN12680-3：铸造-超声探伤-第 3 部分:球墨铸铁/Founding-Ultrasonic examination -part 3: Spherical graphite cast iron castings.ISO 8501-1：表面粗糙度/visual assessment of surface cleanliness993062：超声波设备的校准/Ultrasonic equipment calibration and verificationEN12668－1：无损检测－超声设备的特点和验证－第 1 部分：仪表。EN 12668-1：Non-destructive testing - Characterization and verification of ultrasonic examination equipment - Part 1: instruments.EN12668－3：无损检测－超声设备的特点和验证－第 3 部分：设备组合。EN 12668-3：Non-destructive testing - Characterization and verification of ultrasonic examination equipment - Part 3: Combined equipment.EN12223：无损检测－超声检测－校准试块 No.1 的规范。EN 12223：None destructive testing – Ultrasonic examination - Specification of calibration block no.1.3.0 检验人员/ NDT-PersonnelNDT 人员至少应获得一个下述标准证书的认证：NDT-Personnel must be qualified to one of the following certification standards: GB9445-99：中国机...