三级医院评审医院感染控制考核知识——专家提问要点1、手消毒效果应达到如下相应要求: 卫生手消毒，监测的细菌菌落总数应≤10cfu/ cm2外科手消毒，监测的细菌菌落总数应≤5cfu/cm22、手卫生的 5 个重要时刻二前三后：接触患者前，清洁无菌操作前接触患者后，接触患者周围环境后，接触血液体液后3、哪些情况必须洗手不能卫生手消毒？手部有明显污染时接触可形成孢子的微生物之后4、外科手消毒应遵循哪些原则？先洗手，后消毒不同患者手术之间、手套破损或手被污染时，应重新进行外科手消毒5、对医务人员手有哪些特殊要求？指甲长度不应超过指尖不应戴戒指等装饰物不应戴人工指甲、涂抹指甲油等在高压缸排汽的总管上装有动力控制止回阀，以便在事故情况下切断，防止蒸汽返回到汽轮机，引起汽轮机超速。在高压缸排汽总管的端头有蒸汽冲洗接口，以供在管道安装完毕后进行冲洗，在管道冲洗完成后用堵头堵死。center pin checks and anchoring the inner cylinder. According to While coupling alignment should kep oil out of cavity and locate the rotor axis neck raised are within the prescribed limits, there should be no gaps, Horn, Horn and Horn 0.05mm feler gauges fit into. Center coupling, condenser water filling and water-filled according to factory requirement. For coupling thre supported rotor Center, the mouth under the coupling betwen the value should be as stipulated in the manufacturer, usually 0.15~0.25mm. In the case of coupling connection, if possible, lifting only one bearing end of the support bearing of the rotor, remove the bearing, fitted with special tiles and special lifting tools, disc rotors, check the journal flutter tile, should generally be less than 0.10MM. When the couplings and rotor comes when there is a conflict, the coupling Centre shall prevail. 6.4.5.2.2 shaft looking for: ... 6.4.5.3. Provisional bolt confirmed the positioning of the rotor size, as well as the coupling betwen the adjustment shim thickness accuracy, drawings to met the tech...
