INTERNATIONAL STANDARDISO 22081First edition2021-02Geometrical product specifications (GPS) — Geometrical tolerancing — General geometrical specifications and general size specificationsSpécification géométrique des produits (GPS) — Tolérancement géométrique — Spécifications géométriques générales et spécifications de taille généralesReference number ISO 22081:2021(E)© ISO 2021ISO 22081:2021(E)i© ISO 2021 – All rights © ISO 2021COPYRIGHT PROTECTED DOCUMENTAll rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of the requester.ISO copyright officeCP 401 • Ch. de Blandonnet 8 CH-1214 Vernier, Geneva Phone: +41 22 749 01 11Email: copyright@iso.orgWebsite: www.iso.orgPublished in SwitzerlandISO i© ISO 2021 – All rights ContentsPageForeword........................................................................................................................................................................ ivIntroduction................................................................................................................................................................... v1Scope................................................................................................................................................................... 12Normative references....................................................................................................................................13Terms and definitions.............
