Copyright ASME InternationalProvided by IHS under license with ASMENo reproduction or networking permitted without license from IHSLicensee=FMC Technologies /5914950002 Not for Resale, 05/07/2009 00:24:44 MDTASME Y14.5-2009[Revision of ASME Y14.5M-1994 (R2004)]Dimensioning and TolerancingEngineering Drawing and Related Documentation PracticesA N I N T E R N A T I O N A L S T A N D A R D--`,,`,,,``,`,``,,``,`,`,,,`,`,`-`-Copyright ASME InternationalProvided by IHS under license with ASMELicensee=FMC Technologies ASME Y14.5ADOPTION NOTICEASME Y14.5, Dimensioning and Tolerancing, was adopted on 9 February 2009 for use by the Department of Defense (DoD). Proposed changes by DoD activities must be submitted to the DoD Adopting Activity: Commander,U.S. Army Research, Development and Engineering Center (ARDEC), ATTN: AMSRD-AAR-QES-E, Picatinny Arsenal, NJ 07806-5000. Copies of this document may be purchased from The American Society of Mechanical Engineers (ASME), 22 Law Drive, P.O. Box 2900, Fairfield, NJ 07007-2900, http://www.asme.org.Custodians:Adopting Activity:Army — ARArmy — ARNavy — SA(Project DRPR-2009-003)Air Force — 16Review Activities:Army — CR, IE, MI, PT, TM2Navy — AS, CG, CH, EC, MC, NP, TDAir Force — 13, 99 DLA — DHOSD — SE NSA — NSOther — CM, MP, DC2NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at http://assist.daps.dla.mil.AMSC N/AAREA DRPRDISTRIBUTION STATEMENT A . Approved for public release; distribution is unlimited.--`,,`,,,``,`,``,,``,`,`,,,`,`,`-`-`,,`,,`,`,,`---ASME Y14.5-2009[Revision of ASME Y14.5M-1994 (R2...
