下载后可任意编辑 式玛涂料公司 货油舱涂料施工程序Working procedure for Sigma Coatings Tank Coating Systems本施工程序是以我们的成熟经验编制而成，以确保工程能顺利进行。施工责任应由船厂/承包商承担。虽然有式玛工程师在场监工，但船厂/承包商对正确施工、保证质量负有责任。发布日期 ： 2000 年 10 月式玛涂料公司货油舱涂料施工程序命运如同手中的掌纹，无论多曲折，终掌握在自己手中==============================================================下载后可任意编辑货油舱Working procedure for Sigma Coatings Tank Coating Systems1喷砂前的钢结构表面处理Condition of steelwork prior to gritblasting2通风及湿度控制Moisture control and ventilation3脚手架/台Scaffolding / staging4喷砂Grit blasting5除湿De-humidification6式玛货油舱涂料的施工Application of Sigma Coatings Tank Coating System7货油舱上部涂层的检验Inspection of paint system on upper areas8脚手架的拆除Dismantling and removal scaffolding9货油舱底部涂层的施工及检验Application and inspection of paint10舱底漆膜及甲板管道开口涂层的修补命运如同手中的掌纹，无论多曲折，终掌握在自己手中==============================================================下载后可任意编辑Remedial touching up of paint film in tank bottom and coating of ventilation doors and strums11不锈钢Stainless steel12海水试验Salt water test1喷砂前的钢结构表面处理CONDITION OF STEELWORK PRIOR TO GRITBLASTING所有锐边要打磨至半径最少为 3 毫米的圆角All sharp edges to be ground off to approximately 3.0 millimeters radius asminimum.。清除所有飞溅和焊渣。All welding spatter and slag to be removed所有切割边缘的溶渣须清除洁净。All corner cut-outs to be cleaned of all weld and burn slag.喷砂前任何电焊咬口、气孔须重焊。Any undercuts / blowholes to welds requiring rewelding are to be doneprior to gritblasting所有毛刺应在喷砂前用打磨机磨掉。All plate laminations are to be removed with a grinding machine beforegritblasting1.6 开始喷砂之前，舱内及周边相邻部位的烧焊和火工工程...
