模拟电子课程设计 直流稳压电源 学院: 机电工程学院 专业:应用电子技术 班级:电子一班 学号:………….. 姓名:……… 2010.01.05 2 目 录 一、引言.......................................................................3 二、设计目的................................................................4 三、设计任务和要求.....................................................4 四、设计步骤................................................................4 五、总体设计思路.........................................................5 六、实验设备及原器件..................................................9 七、测试要求.................................................................9 八、设计报告要求..........................................................9 九、注意事项................................................................1 0 十、此电路的误差分析..................................................1 0 十一、心得体会.............................................................1 0 十二、参考文献.............................................................1 1 十三、结束语.................................................................1 1 3 一、引言 直流稳压电源一般由电源变压器,整流滤波电路及稳压电路所组成。变压器把市电交流电压变为所需要的低压交流电。整流器把交流电变为直流电。经滤波后,稳压器再把不稳定的直流电压变为稳定的直流电压输出。本设计主要采用直流稳压构成集成稳压电路,通过变压,整流,滤波,稳压过程将 220V 交流电,变为稳定的直流电,并实现电压可在 6-13V 可调。 关键词:直流;稳压;变压 Abstract The direct current is steady to press the power supply general from power transformer, commutate the an electric circuit and steady ,press the electric circuit constitute.Transformer the low-pressure alternate current that electric voltage need when changing into in exchanges in electricity in municipal.Commutating the machine change into the direct current to the alternate current.Through the an...