注塑常用术语英文表达VIP专享

1.雾气 Moisture Streaks2。玻纤分配不均 Glass Fiber Streaks3。困气 Gas Trap Effect4.银丝纹 Sliver Marks5.结合线 Weld Line6。水波痕 Water Wave Effect7.黑点 Dark Sport8.顶出印 Visible Ejector Marks9.变形 Deformation During Demolding10。填充不足 Short Filling11。冷料流痕 Cold Slug12.进胶口点不良 Dull Spots Near The Sprue13。喷射痕 Jetting14.表面起层 Flaking Of The Surface Layer15。浮泡 Entrapped Air16。过热变色 Burnt Streaks17.龟裂 Stress Crack18.缩水痕 Sink Marks19。真空气泡 Density Bubble20.披锋 Flash21。擦伤印 Scratch MarksGlass fiber rich surface/glass emergence on the surface22 尺寸过大 Over dimension23 尺寸过小 Under dimension 24 翘曲 Warpage/warped 25 收缩 Shrinkage/shrink 26 缩影 Sink marks 27 打不满 Short shot/short molding 塑料模具 mould of plastics 注塑模具 injection mould 冲压模具 die 模架 mould base 定模座板 Top clamping plate Top plate Fixed clamp plate 水口推板 stripper plate A 板 A plate B 板 B plate 支承板 support plate 方铁 spacer plate 底针板 ejector plate 面针板 ejector retainer plate 回针 Return pin 导柱 Guide pin 有托导套 Shoulder Guide bush 直导套 Straight Guide bush 动模座板 Bottom clamp plate Moving clamp plate 基准线 datum line 基准面 datum plan 型芯固定板 core-retainer plate 凸模固定板 punch—retainer plate 顶针 ejector pin 单腔模具 single cavity mould 多腔模具 multi-cavity mould 多浇口 multi—gating 浇口 gate 缺料 starving 排气 breathing 光泽 gloss 合模力 mould clamping force 锁模力 mould locking force 挤出 extrusion 开裂 crack 循环时间 cycle time 老化 aging 螺杆 screw 麻点 pit 嵌件 insert 活动镶件 movable insert 起垩 chalking 浇注系统 feed system 主流道 sprue 分流道 runner 浇口 gate 直浇口 direct gate , sprue gate 轮辐浇口 spoke gate , spider gate 点浇口 pin—point gate 测浇口 edge gate 埋伏浇口 submarine ga...