Australian/New Zealand Standard®澳大利亚/新西兰标准®Electric cables—Polymeric insulatedPart 2: For working voltages above 19/33 (36) kV up to and including 76/132 (145) kV电缆-聚合绝缘第二部分:工作电压大于 19/33 (36) kV 时,电力供应小于等于 76/132 (145) kVThis Joint Australian/New Zealand Standard was prepared by Joint Technical Committee EL/3, Electric Wires and Cables. It was approved on behalf of the Council of Standards Australia on 17 November 1997 and on behalf of the Council of Standards New Zealand on 17 November 1997. It was published on 5 February 1998.本澳/新联合标准由电线和电缆联合技术委员会 EL/3 编制,并以澳大利亚标准委员会的名义于 1997 年11 月 17 日获得审批通过,以新西兰标准委员会的名义于 1997 年 11 月 17 日获得审批通过。并于 1998年 2 月 5 日出版。The following interests are represented on Committee EL/3:EL/3 委员会由以下单位参加:Australasian Railways Association大洋洲铁路委员会Australian Electrical and Electronic Manufacturers Association 澳大利亚电气和电子制造商委员会Department of Defence, Australia澳大利亚国防部Electrical regulatory authorities电气管理机构Electricity Supply Associated of Australia澳大利亚供电协会Institution of Engineers, Australia澳大利亚工程师协会Ministry of Commerce, New Zealand新西兰商业部New Zealand Electrical Contractors Association新西兰电气承包商协会New Zealand Electrical and Electronic Manufacturers Federation 新西兰电气和电子制造商联盟Office of Energy, N.S.W.新南威尔士能源局Testing interests检测机构Review of Standards.标准的审议To keep abreast of progress in industry, Joint Australian/ New Zealand Standards are subject to periodic review and are kept up to date by the issue of amendments or new editions as necessary. It is important therefore that Standards users ensure that they are in possession of the latest edition, and ...