沙特现场钻井英语常用语

钻 井 英 语 常 用 语 1. Mix 800 BBLS spud mud 配800 桶开钻泥浆 2. Hold a spud safety meeting w/crew prior to DRLG 22＂Hole 钻22＂井眼之前，开个安全会 3 . How many bits are there on the rig-floor? 钻台上有多少个钻头 4 . There are two bits on the rig-floor, one is tri-cone bit, the other is a PDC bit. 有两个钻头,一个是三牙轮,一个是PDC 钻头 5. Sweep hole w/100 BBL HVP while you drilled to casing setting point 钻达下套管深度时用100 桶高粘清扫井眼 6. Take a Totco survey if any bit trip ,take a wireline survey if lost circulation occurs otherwise , Drop ToTco. 一旦起钻投测，若井漏，吊测，否测投测。 7. Spot 250 BBLS HVP on Bottom .Drop Totco, slug pipe ,pull out of hole (POOH). 封底 250 桶高垢投测，重浆压钻杆起钻 8. Run casing into hole. 下套管 9. Pooh for 185/8＂CSG ＆ lay down 22＂BHA. 起钻下18-5/8” 套管，甩掉 22” 钻具组合。 10. Circulation bottoms –up 循环一周 11. Mix/pump 400 sacks דG” cement , Dropped plug .Displace w/wtr ,Bumped plug to 1000psi ,check the float ok 混合并打入 400 袋 G 级水泥，投塞子，碰压到 1000psi. 12. Do you perform cement top job ? 打水泥帽了吗？ 13. Center the casing ,weld brace ＆ casing supports, please .Then make up .Flowline ＆ fill up line ,CUT csg(casing) below RT(rotary table). 把套管居中，焊套管支撑，焊出水口和灌浆管线,把转盘底下的多余套管割掉。 14. P/u（pick up） ＆ N/u (nipple up)16＂BHA ＆ RIH(run into hole) to toc(top of cement) , hydro test 组合 16＂BHA 然后下钻，静液观察． 15. Do you make maintenance work regular? 你经常做设备保养工作吗？ 16. What did you do this morning ? 今天早上干了什么？ We clanged the liner ＆ piston of mud pump 2＂. 我们换了２#泵的缸套和活塞 17. It is time for cutting ＆ slipping drlg(drilling) line 该割大绳了 18. Please don’t put too many thi...