华为计算机网络培训实验指导手册2010年8月实验一远程管理网络设备（telnet）...........................................................................................3实验二以太网端口汇聚..............................................................................................................4实验三STP的基本配置.............................................................................................................6实验四Trunk的基本配置...........................................................................................................9实验五VLAN间的三层通信.....................................................................................................11实验六DHCP配置实验.............................................................................................................15实验七文件传输协议配置（FTP）...........................................................................................17实验八PPP、FR配置实验.......................................................................................................18实验九RIP协议配置.................................................................................................................21实验十OSPF协议配置.............................................................................................................24实验十一防火墙和地址转换实验..............................................................................................26实验十二路由引入综合实验......................................................................................................29实验十三L2TP（PPPOE拨入）配置实验................................................................................31实验十四虚拟路由冗余协议（VRRP）实验.............................................................................34案例一动态路由协议深入分析..................................................................................................38案例二企业网综合案例分析......................................................................................................42案例三校园网案例分析............................................................................................................46第1章实验一远程管理网络设备（telnet）1.1组网及业务描述图1-11.2配置参考1.配置路由器的ip地址和PC的ip地址[Quidway]interfaceEthernet0/0[Quidway-Ethernet0/0]ipaddress1.1.1.1255.0.0.0配置完路由器的ip地址，你还需要配置PC的ip地址（比如1.1.1.2255.0.0.0）2.配置路由器Telnet登陆方式a、none方式：[Quidway]User-interfacevty04配置用户[Quidway-ui-vty0]authentication-modenone选择认证方式[Quidway-ui-vty0]userprivilegelevel3配置登陆用户级别b、password方式：[Quidway]User-interfacevty04[Quidway-ui-vty0]authentication-modepassword[Quidway-ui-vty0]setauthenticationpasswordsimple123设置登陆密码[Quidway-ui-vty0]userprivilegelevel3C、scheme方式：[Quidway]User-interfacevty04[Quidway-ui-vty0]authentication-modescheme[Quidway-ui-vty0]userprivilegelevel3[Quidway]local-userhuawei添加管理用户[Quidway-luser-huawei]passwordsimple123456设置用户密码[Quidway-luser-huawei]service-typetelnetlevel3设置服务类型及优先级3.检测PC与路由器的连通性使用ping命令检测，能否ping通路由器；并在PC上运行telnet应用程序登录路由器。实验二以太网端口汇聚1.1上机目标：完成本课程的上机试验后，您应该能够：掌握以太网端口汇聚的配置过程1.2组网及业务介绍：1.3端口汇聚实验配置流程图1.4配置参考交换机Sw1...
