Nov ember 1995Rev is ion 5.1Meter Bus ApplicationANALOG-BOARDRevision 5.1ANALOG-BOARD for the Meter Bu s Application2Dear Customer,Texas Instruments would like to thank you for your request for the ANALOGBOARD Revision 5.1 design kits.The following disclaimer applies to these design kits.In compliance with the EMC Directive (Council Directive of 3 May1989 onthe approximationof the laws of the Members States relating to electro-magnetic compability(89/336/EEC)and the German Act: "Notification of theAmended ElectromagneticCompatibilityAct of 30. August 1995" (para. 5sec. 5 EMVG) the design kits you ordered have not been CE marked. Thetarget users of these design kits are NOT end users, but exclusivelyprofe-ssionals (ie. designers, application engineers, etc.), who are proficient inEMC matters. The design kits are intended for developmentonly.Again, Texas Instruments would like to thank you for your request.If you have anyquestions, please contact your local Texas Instruments FieldSales Representative or one of your factoryrepresentatives.SincerlyTexas InstrumentsJanuary1997ANALOG-BOARD for the Meter Bu s Application3IMPORTANT NOTICETexas Instruments (TI) reserves the right to make changes to its products or to discontinue any semiconductorproduct or service without notice, and advises its customers to obtain the latest version of relevant informationto verify, before placing orders, that the information being relied on is current.TI warrants performance of its semiconductor products and related software to the specifications applicable atthe time of sale in accordance with TI’s standard warranty. Testing and other quality control techniques areutilized to the extent TI deems necessary to support this warranty. Specific testing of al...