下载后可任意编辑 PURCHASE CONTRACT of Plastic Mold 塑胶模具加工中英文版本采购合同BETWEENThe Buyer(Party A): THE BUYERAddress:地址:Postcode 邮编:Contacts 联系人: Tel 电话:Fax 传真:ANDThe Seller (Party B):加工卖方(乙方): Address:东莞市昱卓精密塑胶模具厂地址: Postcode 邮编: Contacts 联系人: Tel 电话: Fax 传真:Signing Place: 签约地点:东莞市大岭山镇大岭村纵队路 93 号Signing Date: ___________________签约日期:After friendly negotiation, Party A and Party B agree to reach this contract as follows for complying with.甲乙双方经友好协商,甲方和乙方一致同意签订以下合同,以便共同遵守。1.Object:合同标的物:序号/No产品编号/Part No注塑产品规格/plastic parts spec模具数量/Quantity of molds模穴数/Mold Cavity模具含 17%税价格(元)/Tooling cost with 17% vat(RMB)1Page/页数: 1/10下载后可任意编辑2345Total乙方根据甲方提供的注塑产品要求负责设计制造模具. 上述模具单价为人民币含 17%税, 包括了模具设计,生产,试模,以及产品在甲方验收合格前的所有相关费用.Party B should design and produce the Molds. The unit price for the molds mentioned above based on RMB(included 17% vat), which includes the design, produce ,trial run cost and any other cost about the Molds before the plastics sample have been approved by Party A. 2. Quality Standard: the quality of goods shall accord with the standard as follows: 质量标准:本合同标的物需符合以下质量标准:(可以多选) According with state standard and industry standard ,if they are not the same, the higher shall prevail 符合国家标准和行业标准,若两者不一致以高者为准It must be at least 500,000pcs good plastic parts which can be produced by the mold in the contract合同中的模具必须可以生产至少 50 万模次的合格产品The plastic products which are produced by the Molds need to meet the requirement of Party A, refer to Appendix1 standard of plastic products.该模具生产的注塑...