故障代码（十六进制)XX51XX50XX54XX52XX53XX56XX57XX58XX59XX5AXX5BXX5CXX55XX5DXX5EXX60-XX6FXX70-XX7FXX80-XX8FXX90XX91XX92XX9300010002000300040005000600070008XX9400090010001100120013001400150016001700180019001F0020002100220023002400250026002700280029002A002B002C002D002E002F00300031003200330034003500360038xx39xx3Axx3Bxx3Cxx3Dxx3E00440045xx50xx51xx52xx53xx54xx55xx56xx57xx58xx59xx5Axx5Bxx5Cxx5Dxx5Exx5Fxx60 toxx6Fxx70 toxx7Fxx90xx91xx92xx93xx94xxA1RSLogix 500- CopyrightRockwellSoftware2000, 2001,2002说明I/O模块存在“Stuck"运行时间故障ABSLC500处理器故障代码存在框架数据故障实际的模块类型与用户程序中的要求的模块类型不一致缺少用户程序中要求的模块当切换至运行时，用户程序声明某一个槽未使用，但系统检测到该槽中插有一块I/O模块，该代码也表示一块I/O模块自己复位用户程序中指定的框架组态不正确特殊I/O模块没有在要求的限定时间内响应锁定共享内存命令特殊I/O模块出现一般性故障。在模块状态字节中该模块故障位被置位成1特殊I/O模块没有在要求的时间内响应并完成一条命令硬件中断问题G文件组态错误，用户编写的G文件大小超过了模块容量M0-M1文件组态错误，用户编写的M0-M1文件大小超过了模块容量实际的I/O点数与用户程序要求的离散量I/O模块点数不一致。该代码也表示专用模块的驱动程序不正确处理器不支持请求的中断服务处理器I/O驱动程序错误用于识别为I/O模块指定的可恢复主要故障用于识别为I/O模块指定的不可恢复主要故障用于识别为特殊I/O模块指定的不可恢复主要故障禁止槽的中断问题禁止槽出现故障无效的或不存在的模块中断子程序（SR)文件不支持I/O模块指定的主要故障NVRAM (non-volatile memory) error occurred. This non-user error occurs at powerUnexpected hardware watchdog timeout. This non-user error occurs at power up.EEPROM memory is corrupt. This non-user error occurs at power up or while goinginto REM Run mode.A memory error occurred while in the Run mode. This non-user error occurs atReservedReservedA failure occurred during a memory module transfer. This non-user error occursat power up.A fatal internal software error occurred. This non-user error occurs at...
